Latest activity
-
travis_farmer replied to the thread Ideas and build log for my CNC Shed.i have been trying to think of a way to improve security, where the side walls are tent fabric. about like locking the doors of a...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.on the carousel changer idea. if the disk has a cover, all but where the change location is, then the home location on the carousel...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.trying to figure out the best way to move the ATC tool rack out of the way... i have a belt and gear reduction assembly that i salvaged...
-
travis_farmer replied to the thread Ideas and build log for my CNC Shed.Far too long since an update... the platform was done quite a while ago. just waiting for spring to move the tent-frame over the...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.I have been making a control panel for my machine. so to start with, i have cut 4 holes in a PVC sheet for the LCD screen, and three...
-
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.had some success today. i wired the PNP sensors to my 7i70, leaving room for the tool pocket sensors. also, i played with the tool...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.been thinking about my 7i70 board, and i think i will use it for more than just the changer inputs. i can use it for any PNP sensor, so...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.i have pretty much given up on the Matrix tool changer idea, in favor of a rack tool changer. mostly for the simplicity, though somehow...
-
travis_farmer posted the thread Brainstorm: Arduino ModBus control (via LinuxCNC), tool changer magazine? in Arduino Projects.using this Arduino Library: https://github.com/CMB27/ModbusRTUSlave Library Mirror, in case original breaks...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.ok, so the tool transfer device will not work as a slider. it will have to be a swing arm. though with this idea, the magazine XYZ-home...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.so, if i build a matrix tool magazine, the tool holders would be filed into BT30 forks. that means that the tool grabber needs to grab...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.so, interesting development... using mb2hal on LinuxCNC, and an Arduino project, https://github.com/CMB27/ModbusRTUSlave, i was able to...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.i have come to the conclusion that search engines and SPAMMERS looking for leaks, are the ONLY people reading my posts here. hence why i...
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.the spindle is mounted, and preliminary wiring is complete. i have even completed the break-in process. i opted to control the VFD with...
-
-
travis_farmer replied to the thread My Techno/ISEL 4 foot square CNC router table build.Attached PDF Manual
